MDH apl pusherssoffsetz Magnus_VLF This NVS parameter specifies how far to jog the pusher down after triggering the inductive plate sensors before turning on the vacuum generators to attempt a slipsheet grab. Increasing this value will move the pusher shoes closer to the top of the plate stack (lower) before turning on the shoe vacuum and attempting to grab the slipsheet. If this parameter is set too low then the pusher vaccum generators may not pick up the slipsheet reliably. If this parameter is set too high then the pusher shoe may contact the plate stack and possibly damage the top plate. This parameter is available.

15.000 [mm]

Please issue the appropriate monitor command to determine this parameter's minimum and maximum values.

25-Jul-2006 Created Normal

..\..\ShowAllErrors.htmFirmware 1 Error Index

..\..\ShowAllCommands.htmFirmware 1 Command Index

..\..\ShowAllParameters.htmFirmware 1 Parameter Index

Updated: Thu Jul 17 07:23:59 2008 PST